Z2-808Ais an all-digital 2 phase stepper driver. It adopts the advanced controlcalculation, no matter how many steps to set, motor current is the accuratesine. The advantages are excellent performance, super stability, low-speed muteand extremely low heat.

255steps for different transmission ratio

Singlepulse, dual pulse

16kinds of output current

11kinds of lock current percentage (0-100%)

16kinds of lock time (0.1-2 seconds)

ENsignal can work as off-line mode or lock mode

Inputsignal can be any value between 5V and 24V

Automaticallyrecord the breaking point when power off

Greatprotection system (undervoltage, over voltage, over current, etc.)

Set steps

Steps for the motorrotating one cycle, 255 different steps, sw1-4 for steps, 14 steps can directlyselect, if need other steps, set sw1-4 to 0000, on=0, off=1

Set current

16 different currents,sw5-8 to set, it’s peak

Input signal

3 signals: CP, DIR, EN,signal value 5~24V, single pulse: CP is pulse signal, one pulse is one step,DIR is direction level signal, the signal must be steady before sending CP,dual pulse: CP is positive pulse signal CW, DIR is negative direction pulsesignal CCW, EN is enable signal, when not connect EN, or differential level is0, then driver is enable status, and driver works well, when EN differentiallevel is 1, then driver is non-enable status, and the driver stopes working,non-enable can set as offline or lock mode, factory set is offline mode.

Lock currentpercentage

Whenthe motor does not work, lock current reduces for less consumption and heat. Differentlock percent is available,0%(offline)-10%-20%-30%-40%-50%-60%-70%-80%-90%-100%(full current), default 50%

Lock time

It takes time that pulsesignal stops lock current and make it work, time 0.1s-2.0s, default 1.0s

Indicator lightstatus